Metal Washer and ribbon necklace

You will need:

20 - 30 1" metal washers (I used 24. Use more or less to make it the length you want.)

5/8" wide grosgrain ribbon, about 1 yard (or more, depending on your desired length of your necklace)

Step 1:

Thread your ribbon up through washer #1, leaving enough ribbon on the end to tie the necklace when it's finished.

Step 2:

Thread the ribbon down through the top of washer #2.

Step 3:

Thread the ribbon back down through washer #1.

Step 4:

Pull the ribbon tight, so washer #2 is laying flat on top of washer #1.

Step 5:

Thread the ribbon back up through washer #2.

Step 6: 

Repeat steps 2 through 5 for each additional washer. Once you've threaded all your washers onto the ribbon, tie the two ends of the ribbon together and trim off the excess.
Ready to wear